ProFoam II

Minimally Expanding Insulating Foam

Features

  • Low Foam Pressure / Low Expansion
  • Quick Setting Formula can be Cut in Less than One Hour
  • Non-Flammable
  • Insulates, Seals and Fills to Eliminate Heat Loss and Noticeable Drafts
  • Environmentally Conscious Product has Zero VOC Content and is GREENGUARD Approved

Sizes

  • 24 fl oz  (680 g)

Colors

  • Off-White (IDH 1538743)

Clean Up

  • OSI Foam Clean

Recommended For

Pro Foam II insulates, seals and fills gaps beneath base plates, mud sills, corner joints, T-joints, exterior cracks, around utility panels, electrical, plumbing and HVAC penetrations, windows and door frames, top plate penetrations, and other areas where air infiltrates or heat loss can occur.  Compatible with electrical wire insulations (ie Romex), rubber, PVC, polyethylene, or other plastic.  Ideal for adhering and joining insulation panels, and when used with the OSI Foam Gun, may be used in place of conventional adhesives for adhering drywall to wood framing.

For Best Results

In cold weather applications, containers should be kept at 65°F (18°C) for maximum performance. Product temperatures below 55°F (13°C) will experience slow extrusion rates.  Not a fire stopping material and should not be used in areas that require fire proof or fire stop materials.  Will not adhere to polyethylene (PE), polytetrafluoroethylene(PTFE)/Teflon®, silicone, oils, greases, mold release agents and similar materials.  Should not be left exposed but should be covered with at least ½” cement plaster or fire-rated gypsum board or an equivalent barrier that will provide a finished fire rating of 15 minutes or more.  Should not be used in contact with chimneys, heater vents, steam pipes or other areas which could be subject to surface temperatures greater than 240°F.  Avoid doing hot work or flame cutting around urethane foams. If necessary, follow the recommended industrial procedures.

Products Just as Tough